Home > Error Codes > Respironics Bipap St/error Codes

Respironics Bipap St/error Codes

Contents

C-206 SMARTCARD_BAD_CDB_START_ADDR Card is corrupt and should be reprogrammed. The system returned: (22) Invalid argument The remote host or network may be down. Please try the request again. Your cache administrator is webmaster. this content

C-5 SMARTCARD_PRESENT_IN_CAL_MODE Remove card. Is there anything we can do to get this working again? DONATE to Apnea Board Change your own pressure - Get the Clinician Setup Manual for your CPAP here 02-25-2012 07:21 PM SuperSleeper Posts: 9,967 Joined: Feb 2012 Machine: PR System One My computer says I need to upgrade my brain to be compatible with its new software. http://www.apneaboard.com/forums/Thread-Equipment-Philips-Respironics-REMstar-BiPAP-Error-Codes

Respironics Bipap Error Codes

Note: this article includes some technical information copied from the REMstar Pro Service Manual. Part of the Main PCA consists of the slot for the Encore SmartCard. INFORMATION POSTED ON THE APNEA BOARD WEB SITE AND FORUMS ARE PERSONAL OPINION ONLY AND NOT NECESSARILY A STATEMENT OF FACT. C-303 SMARTCARD_BAD_UIDB_END_ADDR Card is corrupt and should be reprogrammed.

Is there a specific error code or does it simply say "Service Required"? C-404 SMARTCARD_BAD_DDCB_FOSQ_COMPL_CONTROL_BLOCKS Card is corrupt and should be reprogrammed. Using the Encore software, the usage data can be downloaded and viewed. Philips Respironics System One Error Codes Attached File(s) Thumbnail(s) SuperSleeper Apnea Board Administrator www.ApneaBoard.com INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE.

If I were in control of the company I would want the ones that have the machines to know as much as possible about it. Respironics Bipap Autosv Error Codes C-503 SMARTCARD_FILE_READ_FAIL Card is corrupt and should be reprogrammed. When installed in the REMstar Pro CPAP machine, the SmartCard records the date, time at pressure, pressure levels, and duration of each use. Best wishes, Den (4) REMstar Autos w/C-Flex & (6) REMstar Pro 2 CPAPs w/C-Flex - Pressure Setting = 13 cm. "Passover" Humidification - ResMed Ultra Mirage FF - Encore Pro w/Card

Perhaps card is intended for another device. Remstar Pro Error Codes Perhaps card is intended for another device. Otherwise, replace card. Attached File(s) Thumbnail(s) 02-25-2012 07:22 PM Donate to Apnea Board SuperSleeper Posts: 9,967 Joined: Feb 2012 Machine: PR System One REMstar Auto (DS560) Mask Type: Nasal pillows Mask Make &

Respironics Bipap Autosv Error Codes

If you do ever take apart your CPAP machine, be sure not to plug it in. Top Dryfox Reply with quote Re: Remstar Error Codes by Dryfox on Fri Oct 03, 2008 2:50 am Thanks for list of codes. Respironics Bipap Error Codes SuperSleeper Apnea Board Administrator www.ApneaBoard.com INFORMATION ON APNEA BOARD FORUMS OR ON APNEABOARD.COM SHOULD NOT BE CONSIDERED AS MEDICAL ADVICE. Respironics Cpap Service Required Thread: Author Replies: Views: Last Post Use CPAP machine to get a new baseline AHI?

The motor makes a plastic "fan" spin really fast inside the blower assembly and this spinning fan generates air pressure and pushes the air out of the blower assembly and through http://newsocialweb.org/error-codes/respironics-bipap-autosv-error-codes.html Or, you could purchase another one. REMstar Auto & Pro 2 error codes: Error Code - Description - Probable Cause - Corrective Action E-0 NO_ERROR •Reserved •N/A E-1 ERR_SOFTWARE •Reserved •Replace Main PCA E-2 ERR_PROGRAM_CRC_FAILURE •Defective FLASH Perhaps card is intended for another device. Respironics Cpap Error Codes

C-403 SMARTCARD_BAD_DDCB_HISTOGRAM_CONTROL_BLOCKS Card is corrupt and should be reprogrammed. Your cache administrator is webmaster. No air comes out and the buttons flash and beep. http://newsocialweb.org/error-codes/respironics-bipap-error-codes.html Figure 4 shows the CPAP machine completely separated into two parts.

No error codes showing, and I don't know how to get them otherwise. 02-25-2012 07:23 PM Donate to Apnea Board SuperSleeper Posts: 9,967 Joined: Feb 2012 Machine: PR System One REMstar Remstar Shuttle Error Codes my model #1009587 RemPlus w/C-Flex Intl. Remove card and reinsert properly.

Thread: Author Replies: Views: Last Post [Equipment]Respironics blower failure SleepyinMTL 2 113 12-03-2016 12:52 AM Last Post: trish6hundred REMStar SE with DOT Compliance musicman85 11 371 12-01-2016 09:08 PM

C-506 SMARTCARD_FILE_SET_PTR_FAIL Card is corrupt and should be reprogrammed. (4) REMstar Autos w/C-Flex & (6) REMstar Pro 2 CPAPs w/C-Flex - Pressure Setting = 13 cm. "Passover" Humidification - ResMed Ultra C-5 SMARTCARD_PRESENT_IN_CAL_MODE Remove card. C-501 SMARTCARD_FILE_TELL_FAIL Card is corrupt and should be reprogrammed. Bipap Synchrony Service Manual supply fuse burnt.

C-4 SMARTCARD_SCRIPT_DURING_PROVIDER_MODE Remove card. Otherwise, card is corrupt and should be reprogrammed. C-106 SMARTCARD_BAD_CPB_SCRIPT_READY Card is corrupt and should be reprogrammed. http://newsocialweb.org/error-codes/respironics-bipap-auto-error-codes.html Grady 02-25-2012 07:16 PM Donate to Apnea Board SuperSleeper Posts: 9,967 Joined: Feb 2012 Machine: PR System One REMstar Auto (DS560) Mask Type: Nasal pillows Mask Make & Model: ResMed Mirage

Perhaps card is intended for another device. Some machines are a bit trickier to open, such as the Puritan Bennett 420G. C-403 SMARTCARD_BAD_DDCB_HISTOGRAM_CONTROL_BLOCKS Card is corrupt and should be reprogrammed. Top Madwrespitcopany Posts: 3Joined: Mon Oct 20, 2008 11:08 pmGender: Reply with quote Re: Remstar Error Codes by Madwrespitcopany on Tue Oct 21, 2008 12:11 am Thanks so much for

I have soaked my Goodknight 420s. Thanks Kyle Top Wulfman Posts: 12345Joined: Thu Jul 07, 2005 3:43 pmLocation: Nearest fishing spotGender: Reply with quote by Wulfman on Wed Feb 21, 2007 11:33 am Kyle, The service Exit Provider Mode screens. To help diagnose the issue, it should give you an error code of some type...

Exit Calibration Mode. C-502 SMARTCARD_FILE_SEEK_FAIL Card is corrupt and should be reprogrammed. Micro-processing technology and a motor hooked up to a fan. C-300 SMARTCARD_BAD_UIDB_VERSION Card is corrupt and should be reprogrammed.

I have sent a note to Respironics, and will see if I get a reply.Author PostsViewing 4 posts - 1 through 4 (of 4 total)You must be logged in to reply C-205 SMARTCARD_BAD_CDCB_END_ADDR Card is corrupt and should be reprogrammed.